fbpx

APPLICATION
>Materials

Our specialized Application Center continues to expand our library of
laser-applicable materials. A wider range of material applications
allows you to be creative without being limited.

Engraving problem—how to Improve Engraving Quality in the scan mode of X-swing

some trouble of laser cutter
The engraving quality working on x-swing is generally worse than x-unilateralism, it usually results in ghosting effect or image offset or bi-directional engraving offset, like below.

some trouble of laser cutter

In RDworks, you can adjust the Reverse Interval to improve this issue.
some trouble of laser cutter

1. Open the test file;

Click the link below for the test file:
https://www.thunderlaser.com.au/download/down/Reverse%20interval-%20test.rld

some trouble of laser cutter
You only need to test and adjust for above four speeds then other speed from 1mm/s to 1000mm/s will be calibrate automatically.

 

2. Test and calibrate the Reverse Interval;

Open System Setting window: Config >> System Setting >> General Settings, like below.

some trouble of laser cutter
These are default values for reverse interval, you may need to calibrate them for your machine.

Let’s test and calibrate.
Send the file to your laser machine and test, look at the results with a magnifying glass then adjust the values of reverse interval until the lines will align horizontally, like below.

some trouble of laser cutter
some trouble of laser cutter some trouble of laser cutter

Note: Each time you change the value of reverse interval, please send again file to your machine and test.

End.

Share:

Facebook
Twitter
Pinterest
LinkedIn
Click Cancel to reply

    Table of Contents

    On Key

    Related Posts

    small_c_popup.png

    contact us

      Full Name

      Emall Address

      Phone Number

      Message