Making a difference for our customers
0407963306

Sales Email: sales@thunderlaser.com.au

laser cutter machine machine

Location:Home >troubleshooting >laser cutter machine
Image-1

Thunder Laser Video


How to choose a reliable laser cutter

WATCH NOW
▷ How to choose a reliable laser cutter
laser parametes

Thunder Laser Video


Laser Samples Parameters

WATCH NOW
▷ Laser Samples Parameters

  • Why the red dot pointer not being able to come out from the laser head.

    Why the red dot pointer not being able to come out from the laser head.

    Release Time:2019/06/01Browsing Times:305

    Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. If yes, please open the lower...

  • Chiller alarms unusually

    Chiller alarms unusually

    Release Time:2019/06/01Browsing Times:255

    Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Keep the water level i...

  • Air pump won’t work or no air  assist when job starts

    Air pump won’t work or no air assist when job starts

    Release Time:2019/06/01Browsing Times:250

    Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then ch...

  • Exhaust fan cannot extract smoke  or dust

    Exhaust fan cannot extract smoke or dust

    Release Time:2019/06/01Browsing Times:180

    Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if...

  • Cutting problem– Some point of the same piece  of materials cannot be cut through

    Cutting problem– Some point of the same piece of materials cannot be cut through

    Release Time:2019/06/01Browsing Times:192

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic. Please fix ...

  • Engraving problem—the engraving quality is very poor

    Engraving problem—the engraving quality is very poor

    Release Time:2019/06/01Browsing Times:196

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving graphic. Please fi...

  • The laser tube won’t fire the beam

    The laser tube won’t fire the beam

    Release Time:2019/06/01Browsing Times:190

    Here are the reasons: ● The laser switch is off Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing sign ...

  • X-axis not moving at all

    X-axis not moving at all

    Release Time:2018/11/17Browsing Times:154

    Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below. If they both seem to be wel...