Making a difference for our customers
0407963306

Sales Email: sales@thunderlaser.com.au

troubleshooting troubleshooting
Location:Home > troubleshooting > laser cutter machine > Air pump won’t work or no air assist when job starts
Image-1

Thunder Laser Video


How to choose a reliable laser cutter

WATCH NOW
▷ How to choose a reliable laser cutter
laser parametes

Thunder Laser Video


Laser Samples Parameters

WATCH NOW
▷ Laser Samples Parameters

Air pump won’t work or no air assist when job starts

Release Time:2019/06/01 laser cutter machine Browsing Times:144

Here are the reasons:


● Air compressor break down

How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if air compressor can be turn on normally, like below:

● Wrong setting

The air assist can be controlled by the layer parameter of software, please make sure you have “If Blowing” selected to YES, like below:


Note: If the Processing Mode is Cut, “If Blowing: Yes” must not be changed.

● The air valve is close

Make sure have the manual air valve opened(horizontal means open), like below:

http://www.thunderlaser.com.au/how-to-use-your-laser-machine/how-to-use-the-air-valve.html


End.